Mercury OWC Elite Pro Guia do Utilizador descarregar pdf (Página 8)

OWC MERCURY ELITE PRO DUAL

SYSTEM SETUP

7. Note that while the inner chassis can slide into both sides of the outer enclosure, there is

only one correct way that will allow the screw holes to line up correctly. To determine the

correct orientation of the outer enclosure with the inner chassis, turn the outer enclosure

on its side and look at the bottom. As shown below, the screw holes at the front of the

outer enclosure are close to the silicone feet. The screw holes at the rear of the outer

enclosure are farther away from the silicone feet.

8. Once you have determined the correct orientation,

slide the inner chassis back into the outer enclosure,

as shown to the left.

9. Once the front grill of the inner chassis sits ﬂush with the edge of the outer enclosure,

turn the Mercury Elite Pro Dual on its side again to look at the screw holes on the bottom.

You should be able to see that the screw holes in the outer enclosure line up with the

screw holes in the inner chassis. Use the four smaller screws to fasten the inner chassis to

the outer enclosure, as shown below. The assembly of the Mercury Elite Pro Dual is now

complete.

REAR FRONT

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Mercury OWC Elite Pro Guia do Utilizador Página 8