Mercury OWC Elite Pro Guia do Utilizador descarregar pdf (Página 6)

OWC MERCURY ELITE PRO DUAL

SYSTEM SETUP

2. Once the two screws have been removed,

slide the inner chassis out of the front of the

outer enclosure, as shown to the left. Start

by pushing on the rear of the inner chassis,

then when you are able to get a grip on the

front grill of the inner chassis, pull it the rest

of the way.

3. When removed from the outer enclosure,

the inner chassis will appear as shown below.

Remove the packet of screws and use the

screws as directed later in the assembly

instructions.

4. Install the lower hard drive, as shown below. Slide the SATA connector on the hard drive

into the black SATA connector circled in red. Make sure the drive is ﬁrmly seated in the

black SATA connector before proceeding.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Mercury OWC Elite Pro Guia do Utilizador Página 6