Mercury XR2 Manual de Instalação descarregar pdf (Página 13)

- 13 -

11. Turn bellows nut out and tighten against cable

end adaptor.

54908

a - Bellows Clamp

b - Bellows Nut Tight Against Jam Nut

12. Turn rudder to port to compress bellows as much

as possible. Pull bellows over cable conduit and

secure with bellows clamp.

13. Seal the thru-hull fitting.

a - Thru-Hull Fitting

Shift Cable Adjustment

IMPORTANT: The shift cable MUST BE properly

adjusted. The shift cable is adjusted so that the

reverse gate is not pre-loaded against either the

forward or reverse stop. Pre-load in either posi-

tion may cause failure of the stop and/or prema-

ture wear of the shift cable or control box compo-

nents. It may also cause stiffness of the throttle

control.

1. Thread the cable barrel onto the shift cable.

a - Cable Barrel

2. Use a degreaser and clean off all oil film from the

area on the shift cable shown.

NOTE: Removing the oil film from the shift cable is

necessary to prevent the bellows from sliding on the

cable.

3. Apply Perfect Seal to cable conduit ahead of the

threads.

Perfect Seal

a - Remove Oil Film From This Area

4. Slide the bellows over the shift cable end. Position

and install the bellows onto the cable conduit as

shown. Fasten ends with clamp and cable tie.

1 in. (25.4 mm)

a - Bellows

b - Clamp

c - Cable Tie

5. Loosen the lock nuts and unfasten the top end of

the shift cable retainer.

NOTE: Locknuts do not have to be removed to open

retainer.

a - Shift Cable Retainer

b - Plastic Barrel Holder

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Comentários a estes Manuais

Sem comentários

Mercury XR2 Manual de Instalação Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Motor Mercury XR2