Mercury OWC Elite Pro Manual do Utilizador descarregar pdf (Página 5)

OWC MERCURY ELITE PRO

SYSTEM SETUP

2.1 QUICK START

If you purchased the Mercury Elite Pro as an empty enclosure, proceed to Section 2.2,

Assembly. If you purchased the Mercury Elite Pro with drives already installed, the OWC

Drive Guide formatting utility has been installed on your Mercury Elite Pro. Follow these

steps to use Drive Guide to format your Mercury Elite Pro for OS X (10.4 and later) or Windows

(XP and later). If you do not wish to use Drive Guide to format your Mercury Elite Pro, you can

use the formatting utility of your choice instead.

1. Connect your drive to your computer using the proper cable, then turn on your drive. If

you prefer to use a diﬀerent formatting utility, do so at this time and skip the rest of these

instructions.

2. Your drive will show up as “OWC SETUP”. Open your drive to view its contents.

3. Open the “OWC Drive Guide” application.

4. Follow the simple on-screen instructions to complete the formatting process.

5. Once the formatting is ﬁnished the drive is ready to use.

2.2 ASSEMBLY

NOTE: The following assembly instructions are written for users who purchased the Mercury

Elite Pro as an empty enclosure. The instructions show how to open the Mercury Elite Pro in

order to install a drive. If you purchased the Mercury Elite Pro with a drive already installed,

opening the Mercury Elite Pro before the expiration of the original warranty will

VOID the warranty. If you wish to remove or replace the drive after the expiration of the

original warranty, you may do so at that time.

1. Remove the Mercury Elite Pro from the retail box and the protective plastic bag. Set

the Mercury Elite Pro on its side and look at the bottom of the enclosure. Use a Phillips

screwdriver to remove the two screws, as circled below in red.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Mercury OWC Elite Pro Manual do Utilizador Página 5