Mercury 250 Especificações descarregar pdf (Página 83)

OPERATION

eng 73

3. Turn the ignition key switch back to the "OFF" position, and

squeeze the primer bulb until it feels firm. Turn the ignition

key switch to the "ON" position again for three seconds.

Continue this procedure until the fuel line primer bulb stays

firm.

Before starting, read the prestarting check list and special

operating instructions in the Operation section.

STARTING PROCEDURE

1. Lower the outboard to the "RUN" position. Make sure all the

cooling water intake holes are submerged.

26837

2. Open the fuel tank filler cap vent screw (manual venting fuel

tanks).

19748

3. Position the fuel line primer bulb so the arrow on the side of

the bulb is pointing up. Squeeze the fuel line primer bulb

several times until it feels firm.

27348

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 162 163

Sem comentários

Mercury 250 Especificações Página 83